July 30 Deadline For EAS Equipment Upgrade + SAGE Upgrade Available

eas-logo_300A new set of EAS Rules and Guidelines adopted by the Federal Communications Commission will become effective on July 30, 2016, mandating the following: 

1). All EAS Participants must have an operational EAS Decoder that recognizes the new FCC EAS location ‘FIPS’ Code for “All of United States” #000000.

2). All EAS Participants must have an operational EAS Decoder that recognizes and acts immediately to ‘relay‐to‐air’ an EAS Activation coded with the EAS Event Code; ‘NPT’ (National Periodic Test) that is received with a valid ‘FIPS’ Code.

Sage Users: Firmware Update Notice

Sage Alerting Systems has released a mandatory firmware update for its Sage Digital ENDEC model 3644. This update will enable users to comply with the Federal Communications Commission’s Sixth Report and Order on the Emergency Alerting System, involving the national location code and NPT event processing. You must install the update to continue to receive IPAWS messages. Compliance with Part 11 rules requires implementation by July 30.

http://www.radioworld.com/article/sage-users-note-this-firmware-update/279302

 

SIDEBAR via MAB ABIP Inspector R. Dale Gehman:

Unfortunately, many of the original 1996 vintage EAS Decoders/Encoders must now be replaced as they cannot be upgraded to accomplish both the modified response to receipt of an ‘NPT’ Event Code, nor can they be upgraded to recognize the new ‘000000’ FIPS National Location Code.

An example of vintage EAS Gear that cannot be upgraded includes, but not limited to; TFT’s EAS911, the Gray SAGE ENDEC and most of the 1996 era EAS boxes.

Most Stations previously upgraded to current vintage EAS Gear that polls FEMA’s IPAWS-CAP Server via the Internet, in compliance with the FCC Rules. Licensees should insure that current vintage EAS Gear has the latest software and firmware updates prior to July 30, 2016!

Stations that continue to operate with vintage EAS Gear that has not been upgraded successfully to recognize the National FIPS Code ‘000000’ and upgraded with a modified response to the EAS Event Code ‘NPT’ – will be in violation of the Rules on August 1, 2016, a violation that subjects the Licensee to a significant monetary assessment and notice of violation upon inspection.

Leave a Reply

Your email address will not be published. Required fields are marked *